Top button
Product Name: Top button Heaven ”P"
This is a button which is put on the top of caps or hats.
There are 3 parts: a head, a ring and a pin.
Button size : Heaven P-13 = Approx. 13mm/ Heaven P-15 = Approx. 15mm
Heaven P-19 = Approx. 17mm/ Heaven P-19(M) = Approx. 17mm
Heaven P-25 = Approx. 25mm
Pin : Standard (7mm)/ L (8mm)/ LL (10mm)
Color: white *19mm has two color variations, white & black
MOQ : Heaven P-13, 15, 19 = 600 sets
Heaven P-25 = 300 sets
%E8%8B%B1%E8%AA%9E.png)





※The LL size pin has only translucent color.
![]() ①First, cut the fabric along the inner diameter of the upper die. |
---|
![]() ②Put the fabric onto the upper die and set the head part of the button onto the center of it. |
![]() ③④⑤Push the head part downward up to the bottom with a stick which is attached to the die. |
![]() ③④⑤Push the head part downward up to the bottom with a stick which is attached to the die. |
![]() ③④⑤Push the head part downward up to the bottom with a stick which is attached to the die. |
![]() ⑥Set the lower die to the hand press machine. |
![]() ⑦Set the washer to the lower die. *The convex side of the washer needs to be facing upward. |
![]() ⑧⑨Put the upper die to cover the lower one. |
![]() ⑧⑨Put the upper die to cover the lower one. |
![]() ⑩Put a hand on the upper die and push the handle down slowly. Then confirm whether the hand press machine goes into the center of the upper die vertically. |
![]() ⑪Push the handle down slowly up to the bottom perfectly. |
![]() ⑫It is completed if the fabric is covered the head part properly when you check the back side. |
Note: Product images are for illustrative purposes only and may differ form the actual product. Due to differences in monitors, colors of products may also appear different to those shown on the site.